Installation Guide of The Flaer Revo Via

Step 1: Prepare Your Bike
Before you start installing the Flaer Revo Via, ensure your bike is clean and in good working condition. You may want to place it on a bike stand for easier access to the necessary components. (and find the manual -:))

Step 2: Install the Flaer Revo Via
Follow these general installation steps, but refer to your user manual for model-specific details. Remember to use the rubber mount under bottle cage extender, if your frame is oval.

Step 3: Install the bleeder,
Mount the Unit: Attach the Flaer Revo Via unit to the designated area on your bike. This involve securing it to the rear derailleur hanger. Use the bolt supplied to get the spacing korrekt,

Step 4: Adjust the bleeder,
Make sure the bleeder i parallel, and when pisition is found, finger tight the nossel.

Step 5: Mount the oil chaimber
Secure the Unit: Make sure the Flaer Revo Via unit is securely fastened to your bike, and all cables are properly routed and protected from damage.

Step 6: Feeder cable
When the position is fount, mount the feeder cable

Step 7: Adjustment
OBS* If internal Di2 feed line is used, remove the transparant tube, and raplace with Di2 tube completely,

Step 8: Fine-Tune Your Setup
If necessary, fine-tune the settings and positioning of your Flaer Revo Via to achieve optimal performance and comfort. Again, refer to the user manual for guidance, and remember to leave a little room for movement at the feeder line.

Step 9: Enjoy Your Ride
With the Flaer Revo Via successfully installed and tested, you're ready to enjoy the benefits it provides during your bike rides.